Click to Share

MAKITA 1420 cordless drill battery

Welcome to buy MAKITA 1420 Tool Battery, replacement Cordless Drill Battery for MAKITA 1420, MAKITA power tool battery, The MAKITA 1420 Battery comes with 1 year warranty and high quality batteries at lower prices, fastest delivery.

Manufacturer -
Model # - MAKITA 1420 battery
Submitted By - wwwbatterycompanycomau (Provider)
Country - Australia
Category - Electronics : Battery : MAKITA Battery

Contact   |   Link To Product   |   More Products By This Company


Model No :   MAKITA 1420 battery
Battery Type :   Ni-Cd
Volt :   14.4V
Provider :
Inquire :


Replacement Power Tool Battery for MAKITA 1420

# Battery Type: Ni-Cd
# Volt: 14.4 V
# Capacity: 2000mAh
# Weight: 867.51g
# Dimension: 94.23x93.80x102.90mm
# Color: Red

Descriptions of MAKITA 1420 Power Tool Battery

The aftermarket replacement MAKITA 1420 Cordless Drill Battery is guaranteed to meet or exceed OEM specifications at a reduced price. Our MAKITA Power Tool Battery are made from the highest quality parts and are compatible with the MAKITA 1420 Power Tool. All our Power Tool Battery include a minimum 12 Months Warranty, 30-Day Money Back, Fast Deliver (from Mcevoy Street Alexandia NSW).

How to Care Your MAKITA 1420 Cordless Drill Battery?

A new MAKITA Power Tool Battery comes in a discharged condition and must be charged before use (refer to the devices manual for charging instructions). Upon initial use (or after a prolonged storage period) the digital camcorder MAKITA 1420 battery may require three to four charge/discharge cycles before achieving maximum capacity. New MAKITA Drill Battery needs to be fully charged and discharged (cycled) a few times before it can condition to full capacity. Rechargeable batteries undergo self-discharging when left unused. Always store a Power Tool Battery pack in a fully charged staged for storage. When charging the MAKITA 1420 battery for the first time the device may indicate that charging is complete after just 10 or 15 minutes. This is a normal phenomenon with rechargeable batteries. Remove the camcorder batteries from the device, reinsert it and repeat the charging procedure

It is important to condition (fully discharge and then fully charge) the MAKITA 1420 battery every two to three weeks. Failure to do so may significantly shorten the battery's life (this does not apply to Li-ion batteries, which do not require conditioning). To discharge, simply run the device under the battery's power until it shuts down or until you get a low battery warning. Then recharge the battery as instructed in the user's manual. If the battery will not be in use for a month or longer, it is recommended that MAKITA 1420 cordless drill battery be removed from the device and stored in a cool, dry, clean place.

Invest in a good charger for your camcorder. Ni-MH batteries should not be charged in a NiCad charger, unless the charger is specifically made for both chemistries. There are cheap chargers and there are expensive chargers. Make sure the charger you get has good reviews and is well made. Chargers with micro-controller chips are usually the best choice of your digital camcorder.

Be sure to store your Power Tool Battery properly. Do not leave your batteries in a hot car, or in humid conditions. The best storage conditions are a cool, dry place. The refrigerator is fine if you stick in a packet of silica gel with your MAKITA 1420 battery in a sealed bag to keep them dry. It is a good idea to charge your NiCad or Ni-MH batteries fully before use if they have been in storage.


, , ,

Disclaimer: Submitters of product listings are solely responsible for their content. PRLog can't be held liable for the contents of the product listings.   Report Abuse

Like PRLog?
Click to Share